JVC CA-HXZ55D, GVT0119-001C manual Playing Back a Tape, Locating the Beginning of a Song-Music Scan

You can play back type I tapes.

Playing Back a Tape

1 Press 0 EJECT for the cassette deck.

2 Insert a cassette with the exposed part of the tape down.

3 Close the cassette holder gently.

4 Press TAPE 2 3.

The tape play starts and the tape direction indicator (3 or 2) starts flashing slowly to indicate the tape’s running direction.

•Each time you press the button, “REVERSE” appears for a while on the display and the tape direction changes.

3: plays the front side.

2: plays the reverse side.

•If no cassette is inserted, “NO TAPE” appears on the display.

When the tape plays to the end, the deck automatically stops if the Reverse mode is off. (See “To play both sides repeatedly— Reverse mode.”)

To stop playing, press 7.

To fast-wind to the right or to the left, press ¡ or 1 while the tape is not running.

The tape direction indicator (3 or 2) starts flashing quickly on the display.

• When using the remote control, you can also use ¢ / 4.

To remove the cassette, press 0 EJECT to open the cassette holder.

English

To play both sides repeatedly—Reverse mode

When using the Reverse mode, the tape automatically reverses at the end of one side, starts playing the other side of the tape, and repeats the same process.

On the remote control:

Press REV. MODE while holding down SHIFT.

On the front panel:

Press REVERSE MODE.

The Reverse mode indicator lights up on the display like—.

To cancel the Reverse mode, press the button again so that the Reverse mode indicator lights up on the display like—.

Locating the Beginning of a Song—Music Scan

You can use Music Scan to locate the beginning of a song. Music Scan searches for blank portions that usually separate recorded songs, then plays the next song.

7To find the beginning of the current song

During play, press ¡ or 1 in the opposite direction to the tape play.

The tape direction indicator of the opposite direction to the tape play starts flashing intermittently.

Searching stops automatically at the beginning of the current song, and it starts automatically.

• When using the remote control, you can also use ¢ / 4.

7To find the beginning of the next song

During play, press ¡ or 1 in the same direction as the tape is playing.

The tape direction indicator of the same direction as the tape is playing starts flashing intermittently.

Searching stops automatically at the beginning of the next song, and the song starts automatically.

• When using the remote control, you can also use ¢ / 4.

Music Scan works by detecting a 4-second long blank between each song, so it will not work well in the following cases

•No blank at the beginning of a song.

•Noise (often caused by much use or poor quality dubbing) which fills the blank.

•Long, very soft passages or pauses in a song.

The use of C-120 or longer tape is not recommended, since characteristic deterioration may occur and this tape easily jams in the pinch- rollers and the capstans.

24