Seiko 7T32 manual Resetting the BUILT-IN IC

Page 17

RESETTING THE BUILT-IN IC

In case any of the hands should move improperly, follow the procedure below to adjust the hand movement.

English

CROWN 1

B 30 A

25

5

20

 

10

 

MIN.

 

 

 

 

 

NOTE

CROWN 1 Pull out to second click.

 

A AND B

Press simultaneously.

 

CROWN 1

Push back in to normal posi-

 

tion.

Before using the watch again, be sure to adjust the position of STOPWATCH hands and set the main time and alarm.

17

Image 17
Contents Cal T32 English Contents Seiko Analogue Quartz FeaturesThere are three buttons and two crowns Display and CROWNS/BUTTONSCrown Date SettingWhen setting Hour hand, check that AM/PM is correctly set Time SettingAdjustment of Alarm hands AlarmTion Alarm time settingAlarm engaged Alarm disengaged Alarm ENGAGEMENT/DISENGAGEMENTStopwatch Operation StopwatchStart Stop Reset Measurement of two competitors To measure the hourly average speed of a vehicle TachymeterTo measure the hourly rate of operation Adjusting the Hand Position Resetting the BUILT-IN IC Battery Change Battery Life IndicatorWater Resistance To Preserve the Quality of Your WatchNon-water Resistant Bar10/15/20 Water resistant 5/10/15/20 barMagnetism TemperaturesCare of Case and Bracelet Shocks & VibrationChemicals Precaution Regarding Case Back Protective FilmSpecifications