Aviom A-16CS, A-16R manual Loading . via Midi, Loading One Preset via Midi

If you have edited a mix and have not stored it to a memory location, this mix will not be recalled when the SysEx data is loaded into the A-16R later.

Loading . via MIDI

The A-16R can load Presets saved as either single Preset files or as All Preset files that include the complete set of sixteen memory locations. As when recalling a Preset from the internal memory, you must first enter Recall Mode to load a Preset. (Recall Mode on the A-16R is entered by pressing the RECALL button.)

Remember that you need to have MIDI cables properly connected between the A-16R and your MIDI recording devices to load presets. Connect MIDI Out from your storage device to MIDI In on the A-16R.

Loading One Preset via MIDI

To load a single Preset that was saved to a MIDI recording device, the A-16R must first be placed into Recall Mode. Remember that MIDI reception is activated only when the front panel REMOTE/LOCAL switch is in the LOCAL position.

While waiting for valid MIDI SysEx information, the A-16R will remain in MIDI Recall until a valid A-16R MIDI message is received, or until you press another front panel button to exit MIDI mode. SysEx information for other manufacturer’s devices will pass through the A-16R and be ignored.

To load one Preset:

1.Set the A-16R REMOTE/LOCAL switch to the LOCAL posi- tion.

2.Press the RECALL button. The RECALL button LED flashes.

3.Press the SOLO button to arm the A-16R for MIDI reception. The LED in the SOLO button will blink.

4.Send the single Preset SysEx data from your MIDI storage device.

5.The Preset is loaded into internal memory and is ready to be used as is and/or edited.

6.Save your Preset to an internal memory location.

When a SysEx transfer is complete, the system will display a status message to confirm that the data was received properly. Two messages are possible:

•Valid Data Received - all yellow Mute LEDs will flash

•Invalid Data or MIDI Error - all red Channel LEDs will

59