Aviom A-16R, A-16CS manual Saving All Mix Presets via Midi

Aviom A-16R and A-16CS User Guide

2.Set the A-16R front panel Remote/Local switch to the LOCAL (MIDI On) position.

3.Set up your MIDI recording device so that it is ready to receive MIDI SysEx data.

4.Hold the RECALL and GROUP buttons down to enter Save Mode.

5.While still holding the RECALL and GROUP buttons, press the SOLO button. (After pressing the SOLO button, you can release the RECALL and GROUP buttons.)

6.The current mix is sent out from the A-16R to the MIDI recording device as a data dump.

7.Save your MIDI SysEx data to disk or other storage media used by your MIDI recording device or software application.

When transmitting a single Preset, the sixteen yellow Mute LEDs will light solid for the duration of the transmission to verify the send operation. For single preset file dumps this will be relatively brief. (Note that there is no way that the A-16R can know that the MIDI Preset data file was received properly by the device that the transmission was intended for.)

Saving All Mix Presets via MIDI

To save the currently saved set of sixteen mix Presets as a single MIDI SysEx data file:

1.Make sure that the A-16R front panel REMOTE/LOCAL switch is set to the LOCAL (MIDI On) position.

2.Set up your MIDI recording device so that it is ready to receive MIDI SysEx data.

3.Hold the A-16R front panel RECALL and GROUP buttons down to enter Save Mode.

4.While still holding the RECALL and GROUP buttons, press the MUTE button. (You can then release the RECALL and GROUP buttons.)

5.The contents of the internal memory of the A-16R is sent to the MIDI recording device as a single data dump.

6.Save your MIDI SysEx data to disk or other storage media as used by your MIDI recording device.

During the transmission of the Preset memory, the sixteen yellow Mute LEDs in the Channel buttons will light solid for the duration of the SysEx transmission.

Note that only the sixteen saved Presets are transmitted as MIDI data.

58