Seiko 7T32 manual Time Setting, When setting Hour hand, check that AM/PM is correctly set

Page 7

TIME SETTING

Hour hand

Minute hand

 

 

1

 

60

45

15

2

 

30

 

 

 

 

 

3

Second hand

CROWN 1

CROWN 1

1Pull out to second click when Second hand is at the 12 o’clock

position.

2Turn to set Hour and Minute

hands.

3Push back in to normal position in accordance with a time signal.

English

NOTES

1When setting Hour hand, check that AM/PM is correctly set.

*The watch is so designed that the date changes once in 24 hours. Turn the hands past the 12 o’clock marker to determine whether the watch is set for the A.M. or P.M. period. If the date changes, the time is set for the A.M. period. If the date does not change, the time is set for the P.M. period.

2When setting Minute hand, advance it 4 to 5 minutes ahead of the desired time and then turn it back to the exact minute.

7

Image 7
Contents Cal T32 English Contents Seiko Analogue Quartz FeaturesThere are three buttons and two crowns Display and CROWNS/BUTTONSCrown Date SettingWhen setting Hour hand, check that AM/PM is correctly set Time SettingAdjustment of Alarm hands AlarmTion Alarm time settingAlarm engaged Alarm disengaged Alarm ENGAGEMENT/DISENGAGEMENTStopwatch Operation StopwatchStart Stop Reset Measurement of two competitors To measure the hourly average speed of a vehicle TachymeterTo measure the hourly rate of operation Adjusting the Hand Position Resetting the BUILT-IN IC Battery Change Battery Life IndicatorBar To Preserve the Quality of Your WatchWater Resistance Non-water Resistant10/15/20 Water resistant 5/10/15/20 barShocks & Vibration TemperaturesMagnetism Care of Case and BraceletChemicals Precaution Regarding Case Back Protective FilmSpecifications