STEP 12 (See Diagram 12 & Butterfly Cable Loop Diagram)
A.) Clip one end of the 96” Butterfly Cable (#45) to the open slot on the Right Butterfly (#10). B.) Draw the Cable to the open bracket on the right side of the Right Vertical Frame (#4).
Attach a Small Pulley (#68) to the bracket.
C.) Secure it with one M10 x 1 ¾” Allen Bolt (#93), two Ø ¾” Washers (#100), and one M10 Aircraft Nut (#102).
D.) Draw the Cable around the Small Pulley to the right open bracket on the Right Base Frame (#31). Repeat Procedure C above to install a Pulley.
E.) Draw the Cable around the Pulley then upward to the Angled Double Floating Pulley Bracket (#27) previously installed in Step
F.) Draw the Cable around the Pulley then downward to the left open bracket on the Right Base Frame. Repeat Procedure C above to install another Pulley.
G.)Draw the Cable around the Pulley to the left open bracket on the Right Vertical Frame. Install a Small Pulley to the bracket.
H.) Draw the Cable around the Small Pulley then clip the end of the Cable to the open slot on the Left Butterfly.
I.) Attach the Butterfly Base Cover (#21) to the Butterfly Base (#13) to cover the left and right pivot on the Butterfly Base. Secure the Cover to the Pivot with two M10 x ¾” Allen Bolts (#95) and Ø ¾” Washers (#100).
J.) Align the holes and secure the Cover to the Butterfly Base with two M10 x 3 3/8” Allen Bolts (#91), four Ø ¾” Washers (#100), and two M10 Aircraft Nuts (#102).
24