Assembly Instruction

Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches

NOTE: It is strongly recommended two or people assembling this machine to avoid possible injury.

STEP 1 (See Diagram 1)

A.)	Place the Right Base Frame (#31) on a flat surface. Make sure there is enough space
	around to assemble the machine.
B.)	Insert four Guide Rods (#16) into the holes on the Right Base Frame. Secure each
	Guide Rod from bottom with a M10 x ¾” Allen Bolt (#95) and Ø ¾” Washer (#100).
C.)	Attach four Ø 2 3/8” x 1” Rubber Bumpers (#52) to top of the Guide Rods then slid down
	to the stopper on the Guide Rods.
D.)	Attach the Right Vertical Frame (#4) onto the Right Base Frame. Secure it with two M10
	x 2 ¾” Carriage Bolts (#98), one 4 ¾” x 2 ¾” Bracket (#25), two Ø ¾” Washers (#100),
	and two M10 Aircraft Nuts (#102).
E.)	Attach the Butterfly Base (#13) to the Right Base Frame (#31). Attach the Front Base
	Frame (#12) to the Butterfly Base (#13) from the front. Align the holes and secure them
	together with two M10 x 3 ¾” Carriage Bolts (#97) from side, two M10 x 2 ¾” Carriage
	Bolts (#98) from the bottom, four Ø ¾” Washers (#100), and four M10 Aircraft Nuts
	(#102).
F.)	Slide fourteen Weight Plates (#80) onto the rear set of Guide Rods. Make sure the
	groove on the plates all face toward the back of the machine.
G.)	Insert a Selector Rod (#28) into the center holes. Slide a Selector Stem (#81) onto the
	two Guide Rods.
H.)	Insert a Weight Selector Pin (#74) to select the number of weight plates. Each Weight
	Plate weights approximately 10 lbs. Please refer to the Weight Resistance Chart in page
	35.
I.)	Repeat procedures F, G and H above to install the other fourteen Weight Plates onto the
	front two Guide Rods.
J.)	Attach the Foot Plate (#17) to the Front Base Frame (#12). Secure it with the Foot Plate
	Axle (#18).