ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches.
NOTE: It is strongly recommended that two or more people assemble this machine to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Do not tighten all nuts and bolts until instructed to do so.
B.) Attach the Left Diagonal Support (#3) to the Left Upright Beam (#1) from rear. Attach the Cross Brace (#5) to the Left Upright Beam from the other side. Secure them together with two M10 x 4” Carriage Bolts (#32) from side, two Ø ¾” Washers (#40), and two M10 Aircraft Nuts (#43).
Secure with two M10 x 2 1/8” Allen Bolts (#36) and two Ø ¾” Washers (#40) from front into Left Diagonal Support. Repeat the same step to install the other side of Cross Brace, Right Diagonal Support (#4), and Right Upright Beam (#2) together.
C.) Place the Backrest Adjustment Bar (#8) onto the selected slot on the Upright Beams to obtain the desired Backrest incline.
DIAGRAM 1
6