Impex MD-PWR-20 manual Securely tighten all Nuts and Bolts

STEP 6 (See Diagram 6)

A.) Do not tighten Nuts and Bolts until instructed to do so.

B.) Align the bracket on the Backrest Adjustment Support (#32) in between the two Backrest Supports (#35). Secure it with four M8 x 1 5/8” Allen Bolts (#81), eight Ø 5/8” Washers (#85), and four M8 Aircraft Nuts (#87).

C.) Insert the Backrest Adjustment Support into the opening on the Main Seat Support (#18). Press or step down on the Backrest Adjustment Lever (#36) to allow the Support to go through.

D.) Attach the bottom side-holes on the two Backrest Support to the pivot on the Main Seat Support. Secure it with one M10 x 6 ½” Allen Bolt (#72), two Ø ¾” Washers (#84), and one M10 Aircraft Nut (#86).

E.) Attach the Backrest Board (#29) to the Backrest Supports. Secure it with four M8 x 1 5/8” Allen Bolts (#81) and Ø 5/8” Washers (#85).

F.) Attach the Seat Pad (#30) to Seat Bracket (#24). Secure it with four M8 x 1 5/8” Allen Bolts (#81) and Ø 5/8” Washers (#85).

G.)Securely tighten all Nuts and Bolts.

H.) When adjusting the Backrest Board to an incline position, simply pull up the Board. When adjusting the Board to a decline position, press or step down on the Backrest Adjustment Lever to disengage the Lever to allow the Board to go down.

DIAGRAM 6

12