STEP 5 (See Diagram 5 & Cable Loop Diagram)
A.) | Attach the 330” Upper Cable (#51) to the swivel pulley |
| the Right Lat Bar Frame (#9). Install a Ball Stopper (#46) onto the end of the |
| Cable. Attach the |
B.) | Attach a Short Chain (#30) in between the openings on the Connector and secure it |
| with a M10 x 1 3/8” Allen Bolt (#62), two ∅ 3/4” Washers (#67), and one M10 |
| Aircraft Nut (#69). |
C.) | Draw the Cable over the Pulley and pull through the Cable sleeve on the Right Lat |
| Bar Frame. Draw the Cable along the Frame towards the back of the machine to |
| the Pulley previously installed. Draw the Cable around the Pulley then downward to |
| the Double Floating Pulley Bracket (#24). |
D.) | Attach two Pulleys (#36) to the Bracket. Secure them with a M10 x 2 ¾” Allen Bolt |
| (#59), two Ø ¾” Washers (#67), and one M10 Aircraft Nut (#69). |
E.) | Draw the Cable around the back Pulley then upward to the open bracket on the |
| bottom of the Lat Bar Frame Bracket (#20). Install another Pulley. |
F.) | Draw the Cable around the Pulley then back down to the Double Floating Pulley |
| Bracket (#24) again. Let the Bracket hanging for now. |
G.) | Draw the Cable around the front Pulley then upward towards the Pulley on the Left |
| Lat Bar Frame (#10). |
H.) | Draw the Cable over the Pulley then along the Left Lat Bar Frame (#10) towards |
| the front of the machine. Insert the Cable through the Cable sleeve and over the |
| |
I.) | Install a Ball Stopper (#46) at the end of the Cable and attach a |
| Connector (#28) to the end. Attach a Short Chain (#30) in between the openings |
| on the Connector and secure it with a M10 x 1 3/8” Allen Bolt (#62), two ∅ 3/4” |
| Washers (#67), and one M10 Aircraft Nut (#69). |
J.) | Connect the Lat Bar (#11) or Single Handles (#33) to the Short Chains using C- |
| clips (#32). |
10