Impex PWR 8 manual See Diagram

Page 9

STEP 4 (See Diagram 4)

A.) Attach the Lat Bar Frame Bracket (#20) to the top of the Rear Vertical Frame (#7). Secure it with two M10 x 5/8” Allen Bolts (#64) and Ø ¾” Washers (#67).

B.) Attach the Left & Right Lat Bar Frames (#10 & 9) to the Lat Bar Frame Bracket (#20). Secure them with two M10 x 5 ¼” Allen Bolts (#57), four Ø ¾” Washers (#67), and two M10 Aircraft Nuts (#69).

C.) Secure each Lat Bar Frame to the Upper Frame (#8) with one M10 x 4 ½” Allen Bolt (#58), two

ؾ” Washers (#67) and one M10 Aircraft Nut (#69). D.) Securely tighten all Bolts and Nuts previously installed.

E.) Attach a Pulley (#36) to the open slot on the Left Lat Bar Frame (#10). Secure it with one M10 x 2 1/8” Allen Bolt (#60), two 5/8” Pulley Bushings (#49), and one M10 Aircraft Nut (#69). Repeat the same procedure to install the other side.

F.) Attach a Pulley to the Lat Bar Frame Bracket (#20). Secure it with one M10 x 1 ¾” Allen Bolt (#61), two Ø ¾” Washers (#67), and one M10 Aircraft Nut (#69).

G.) Insert the Right & Left Bar Catches (#18 & 19), Right & Left Safety Catches (#16 & 17) into the selected holes on the Upright Beams to obtain the desired position.

8

Image 9
Contents Powerhouse Club Before YOU Begin Table of ContentsImportant Safety Notice SQUAT/LAT Pull Hardeware Pack SQUAT/LAT Pull Hardeware Pack Diagram SQUAT/LAT Pull Machine Assembly InstructionSee Diagram Diagram See Diagram Cable Loop Diagram See Diagram 5 & Cable Loop Diagram Diagram See Diagram 6 & Cable Loop Diagram Exploded Diagram Description SQUAT/LAT Pull MachineMULTI-PURPOSE Bench Hardware Pack MULTI-PURPOSE Bench Assembly Instruction See Diagram Diagram Diagram Diagram Page MULTI-PURPOSE Bench Parts List Impex INC