JVC UX-P30 manual Connecting Speakers, Release the finger from the clamp, AM antenna

Page 12

English

AM antenna	Connecting Speakers

]]

ANTENNA

1	3

2

1

Vinyl-covered wire (not supplied)

AM EXT

AM LOOP

FM 75

COAXIAL

			Red
		RIGHT	LEFT
		MAIN
		SPEAKERS
	Speaker	SPEAKER	Speaker
	cord	SPEAKER	cord
		IMPEDANCE
		MIN 4
			Black

2

AM loop antenna (supplied)

1Connect the AM loop antenna to the AM LOOP terminals as illustrated.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Right speaker

Left speaker

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord into the terminal.

Match the polarity of the speaker terminals: Red ª to red ª and black · to black ·.

• If the cords are covered with insulation, remove a short section of insulation at the end of each cord by twisting and pulling it off.

3Release the finger from the clamp.

•DO NOT connect speakers while the power is

on.

• DO NOT connect more than one speaker to each speaker teminal.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

7

Image 12

Contents Instructions PRECAUCIÓN--Botón en espera/encendido Precaución 15 cm To Beam Precautions IntroductionAbout This Manual Contents Location of the Buttons and Controls Front PanelFront Panel Display Window Front Panel Display WindowRemote Control Supplied Accessories Connecting Antennas Getting StartedFM antenna To connect an outdoor FM antennaConnecting Speakers Release the finger from the clampAM antenna To connect an outdoor AM antennaConnecting Other Equipment Adjusting the Voltage Selector To connect audio equipmentTurning On the Power Setting the ClockSetting the AM Tuner Interval Spacing Common OperationsAdjusting the Volume Selecting the Sound ModesTo select the sound modes, press For private listeningTuning in a Station Presetting StationsListening to FM and AM Broadcasts Tuning in a Preset Station Playing Back Discs CD/CD-R/CD-RW Playing Back the Entire Disc-Normal PlayPress CD 0 or 0 on the unit Press CD 3/8Basic Disc Operations Program PlayRepeat to program other tracks you want Press CD 3/8 Load a discTo cancel the prohibition and unlock Disc, press Repeating Tracks-Repeat PlayTo use Random play mode, press Random To skip the current track, press ¢ or Multi KEYPlaying Back Tapes Playing Back a TapeRecording Recording on a TapeCheck the recording direction for the tape Press RECDisc Direct Recording One Track Recording Play the track on the disc you wish to Record Press RECRepeat steps 2 and 3 to record other tracks You wantUsing the Timers Using Daily Timer and Recording TimerUsing Sleep Timer Press Timer to complete the timerSetting Press Standby/on to turn Press SleepMaintenance Handling discs Cleaning the unitHandling cassette tapes Troubleshooting SpecificationsMicro Component System