English
Common Operations
Turning On the Power
When you press the play
To turn on the unit, press STANDBY/ON 
(or 
on the unit).
The STANDBY lamp on the unit goes out.
STANDBY/ON | STANDBY |
To turn off the unit (on standby), press STANDBY/ON 
(or 
on the unit) again.
The STANDBY lamp lights up.
• The CLOCK indicator flashes on the display until you set |
the |
will appear on the display while the power is off. |
2 Press ¢ or 4 to adjust the hour, then press CLOCK.
The minute digits start flashing on the display.
CLOCK
3 Press ¢ or 4 to adjust the minute, then press CLOCK.
The CLOCK indicator remains lit on the display.
CLOCK
4 7 ¢
CLOCK
4 7 ¢
CLOCK
• A little power is always consumed even while the unit is on |
standby. |
To switch off the power supply completely, unplug the AC power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs
The clock is reset to “0:00” right away, while the tuner preset stations (see page 11) will be erased in a few days.
To check the clock time
Press DISPLAY (or CLOCK on the unit) while | DISPLAY |
playing any source. |
|
• Each time you press the button, the source |
|
indication and the clock time alternate on the | CLOCK |
display. |
|
•When you unplug the AC power cord or if a power failure occurs, the clock loses the setting and is reset to “0:00.” You need to set the clock again.
•The clock may gain or lose 1 to 2 minutes per month.
Setting the Clock
Before operating the unit any further, first set the clock built in this unit. When you plug the AC power cord into the wall outlet, the CLOCK indicator starts flashing on the display.
You can set the clock when the unit is either turned on or in standby mode.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the unit ONLY:
1 Press CLOCK for more than 2 | CLOCK |
| |
seconds. |
|
The hour digits start flashing on the display.
CLOCK
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing. When shipped, the
You can change it to 9 kHz or 10 kHz spacing only while the unit is on standby.
On the unit ONLY:
To select 10 kHz intervals, | 4 | 7 | ¢ | |
press | while holding ¢. |
|
|
|
To select 9 kHz intervals, |
|
|
| |
press | while holding 4. |
| STANDBY |
|
|
|
|
| |
When you change the setting
The preset stations are erased. You will need to preset the stations again. (See page 11.)
9