JVC UX-P30 Connecting Other Equipment Adjusting the Voltage Selector, To connect audio equipment

Page 13

English

Connecting Other Equipment		Adjusting the Voltage Selector

You can connect audio equipment—used only as a playback device.

Before plugging in the unit, set the correct voltage for your area with the voltage selector on the rear of the unit.

•DO NOT connect any equipment while the power is on.

•DO NOT plug in any equipment until all connections are complete.

To connect audio equipment

Be sure that the plugs of the audio cords are colored: White plugs and jacks are for left audio signals, and red ones for right audio signals.

AUX

RL

VOLTAGE

SELECTOR

220V

127V

230V

Voltage mark

110V

To audio output

Audio equipment

For playing the other equipment through this unit, connect between the audio output jacks on the other equipment and AUX jacks by using audio cords (not supplied).

Use a screwdriver to rotate the voltage selector so the voltage number the voltage mark is pointing at is the same as the voltage where you are plugging in the unit. (See the back cover page.)

DO NOT plug in before setting the voltage selector on the rear of the unit and all connection procedures are complete.

Now, you can plug the AC power cord.

•If the wall outlet does not match the AC plug, use the supplied AC plug adaptor.

IMPORTANT: Be sure to check all connections to be done before plugging the AC power cord into a wall outlet.

8

Image 13

Contents Instructions PRECAUCIÓN--Botón en espera/encendido Precaución 15 cm To Beam Introduction PrecautionsAbout This Manual Contents Front Panel Location of the Buttons and ControlsFront Panel Front Panel Display Window Display WindowRemote Control Getting Started Supplied Accessories Connecting AntennasFM antenna To connect an outdoor FM antennaRelease the finger from the clamp Connecting SpeakersAM antenna To connect an outdoor AM antennaTo connect audio equipment Connecting Other Equipment Adjusting the Voltage SelectorSetting the Clock Turning On the PowerSetting the AM Tuner Interval Spacing Common OperationsSelecting the Sound Modes Adjusting the VolumeTo select the sound modes, press For private listeningPresetting Stations Tuning in a StationListening to FM and AM Broadcasts Tuning in a Preset Station Playing Back the Entire Disc-Normal Play Playing Back Discs CD/CD-R/CD-RWPress CD 0 or 0 on the unit Press CD 3/8Program Play Basic Disc OperationsRepeat to program other tracks you want Press CD 3/8 Load a discRepeating Tracks-Repeat Play To cancel the prohibition and unlock Disc, pressTo use Random play mode, press Random To skip the current track, press ¢ or Multi KEYPlaying Back a Tape Playing Back TapesRecording on a Tape RecordingCheck the recording direction for the tape Press RECPlay the track on the disc you wish to Record Press REC Disc Direct Recording One Track RecordingRepeat steps 2 and 3 to record other tracks You wantUsing Daily Timer and Recording Timer Using the TimersPress Timer to complete the timer Using Sleep TimerSetting Press Standby/on to turn Press SleepHandling discs Cleaning the unit MaintenanceHandling cassette tapes Specifications TroubleshootingMicro Component System