JVC UX-P30 manual Playing Back Tapes, Playing Back a Tape

Playing Back Tapes

You can play back type I tapes. To stop playing, press 7.

English

Playing Back a Tape

1 Press ) on the unit.

		O	R	E	V	E	R	S	E
A U	T

PHONES

2 Put a cassette in with the exposed part of the tape down.

To fast-wind to the left or to the right, press ¢ or 4 while the tape is not running.

The tape direction indicator (3 or 2) starts flashing quickly on the display.

To remove the cassette, press ) on the unit.

To play both sides—Reverse Mode

You can set the deck to play just one side of a tape, both sides once, or both sides continuously.

On the unit ONLY:
Press REV.MODE.	REV.MODE
• Each time you press the button, reverse mode
changes as follows:

							E	R	S	E
		T	O	R	E	V
A	U

PHONES

3 Close the cassette holder gently.

							E	R	S	E
				R	E	V
		T	O
A	U

PHONES

4 Press TAPE 2 3. TAPE

The unit automatically turns on and the tape play starts. The tape direction indicator (3 or 2) flashes slowly on the display.

•Each time you press the button, the tape direction changes.

3 : plays the front side.

2 : plays the reverse side.

When the tape plays to the end, the deck automatically

stops if the reverse mode is set to or . (See “To play both sides—Reverse Mode.”)

: The deck automatically stops after playing both sides of the tape. (Stops when playback in the 2 direction is finished.)

: The deck continues to play both sides of the tape until 7 is pressed.

: The deck automatically stops after playing one side of the tape.

The use of the C-120 or longer tape is not recommended, since characteristic deterioration may occur and this tape easily jams in the pinch rollers and the capstans.

16