Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and other countries use 10 kHz spacing.
On the front panel ONLY:
To select the 10 kHz interval:
Be sure the receiver is turned off, but is plugged into an AC outlet.
Hold down TUNER PRESET and press STANDBY/ON 
. Now
Storing the Basic Settings and Adjustments — One Touch Operation
JVC’s One Touch Operation function is used to assign and store different sound settings for each different playing source. By using this function, you do not have to change the settings every time you change the source. The stored settings for the newly selected source are automatically recalled.
The following can be stored for each source:
English
the 10 kHz interval is selected.
TUNER PRESET
STANDBY
• | Volume level (see page 10) |
• | Loudness (see page 11) |
and
STANDBY/ON
To change back to the 9 kHz interval:
Be sure the receiver is turned off, but is plugged into an AC outlet.
Hold down FM MODE and press STANDBY/ON 
. Now the 9 kHz interval is selected.
STANDBY
FM MODE
and
STANDBY/ON
Using the Sleep Timer
Using the Sleep Timer, you can fall asleep to music and know the receiver will turn off by itself rather than play all night.
From the remote control ONLY:
Press SLEEP repeatedly. | SLEEP |
The SLEEP indicator lights up on the display, and the
10 
20 
30 
40 
50 
60 
70 
80 
90
00(Canceled) 
When the
The receiver turns off automatically.
To check or change the time remaining until the
Press SLEEP once.
The remaining time until the
• To change the
To cancel the Sleep Timer
Press SLEEP repeatedly until “SLEEP 00min.” appears on the display. (The SLEEP indicator goes off.)
• Turning off the power also cancels the Sleep Timer.
• Input attenuator mode (see page 11) |
• Subwoofer output level (see page 11) |
• Balance (see page 12) |
• Analog/digital input mode (see page 13) |
• SEA modes (see page 19) |
• DSP modes |
– |
– DAP mode settings (see page 23) |
– Surround mode settings (see page 24) |
• DVD MULTI playback mode settings (see page 29) |
On the front panel ONLY:
To store the sound settings
1. Press ONE TOUCH OPERATION. ONETOUCHOPERATION
The ONE TOUCH OPERATION lamp lights up, then the previously memorized settings are recalled.
2. Adjust the sound using the functions listed above.
The newly adjusted settings are memorized.
To recall the sound settings
With the ONE TOUCH OPERATION lamp lit, the settings for the currently selected source are recalled when the source is selected.
To cancel the One Touch Operation function
Press ONE TOUCH OPERATION so that the lamp goes off. (Even though the One Touch Operation function is canceled, the recalled sound effects remain active.)
Notes:
•If the source is FM or AM, you can assign a different setting for each band.
•The DSP modes and DVD MULTI playback mode cannot be used at the same time.
16