JVC RX-889PGD manual FM tuner IHF, AM tuner, Tuning Range Usable Sensitivity Signal-to-Noise Ratio

Page 55

FM tuner (IHF)

Tuning Range:

Usable Sensitivity:

50 dB Quieting Sensitivity:

Signal-to-Noise Ratio (IHF-A weighted):

Total Harmonic Distortion:

Stereo Separation at REC OUT:

Alternate Channel Selectivity:

Frequency Response:

AM tuner

Tuning Range:

Usable Sensitivity:

Signal-to-Noise Ratio

General

Power Requirements:

Power Consumption:

Dimensions (W x H x D):

Mass:

87.50 MHz to 108.00 MHz

Monaural:	12.8 dBf (1.2 µV/75 ohms)
Monaural:	21.3 dBf (3.2 µV/75 ohms)
Stereo:	41.3 dBf (31.5 µV/75 ohms)
Monaural:	78 dB at 85 dBf
Stereo:	73 dB at 85 dBf
Monaural:	0.4% at 1 kHz
Stereo:	0.6% at 1 kHz
35 dB at 1 kHz
45 dB: (±400 kHz)

30 Hz to 15 kHz: (+0.5 dB, –3 dB)

531 kHz to 1,602 kHz (at 9 kHz intervals)

530 kHz to 1,600 kHz (at 10 kHz intervals)

Loop antenna	400 µV/m
	50 dB (100 mV/m)

AC 110/127/220/230-240 V , adjustable with the voltage selector, 50/60 Hz

250 watts (at operation)

2 watts (in standby mode)

435 x 157 x 412.5 mm

(17 3/16 x 6 3/16 x 16 1/4 inches)

11.3 kg (25.0 lbs)

Designs & specifications are subject to change without notice.

English

52

Image 55

Contents RX-889PGD Precaución English Español Table of Contents Parts Identification Remote ControlFront Panel Getting Started Before Installation Connecting the FM and AM AntennasChecking the Supplied Accessories Setting the Voltage Selector SwitchAM Antenna Connections Connecting the SpeakersBasic connecting procedure Connecting the front speakersAbout the speaker impedance Connecting Audio/Video ComponentsConnecting the rear and center speakers Connecting the subwoofer speakerTo audio input MD recorder To audio output CD playerTo audio input Cassette deck To audio output VHS or VHS VCRDVD player To S-video outputTo composite ‚ To composite video outputDigital connections Connecting the Power CordPutting Batteries in the Remote Control Plug the power cord into an AC outletSelecting the Source to Play Turning the Power On and Off StandbyFrom the remote control Basic OperationsSelecting different sources for picture and sound Adjusting the VolumeSelecting the Front Speakers EtcMuting the Sound Attenuating the Input SignalListening at Low Volume Loudness Adjusting the Subwoofer Output LevelRecording a Source Basic SettingsAdjusting the Front Speaker Output Balance Setting the Subwoofer InformationSelecting the Analog or Digital Input Mode Digital Input Digital in Terminal SettingShowing the Text Information on Display Rear Delay Time Setting Setting the Speakers for the DSP ModesCenter Delay Time Setting Front, Center, and Rear Speaker SettingFrequency appears on the display Crossover Frequency SettingLow Frequency Effect Attenuator Setting Dynamic Range Compression SettingPress ONE Touch OPERATION. Onetouchoperation Setting the AM Tuner Interval SpacingUsing the Sleep Timer Adjust the sound using the functions listed aboveTuning in Stations Manually Using Preset TuningReceiving Radio Broadcasts Selecting the FM Reception Mode Assigning Names to Preset StationsSelecting Your Favorite SEA Mode Using the SEA ModesCreating Your Own SEA Mode 3D-PHONIC modes Using the DSP ModesDAP modes Surround modes DVD Multi Playback ModeFront Available DSP Modes According to the Speaker ArrangementAdjusting the DAP Modes Adjusting the 3D-PHONIC ModesAdjusting the Surround Modes Surround ON/OFF to activate An appropriate Surround modeAdjust the center tone Press DOLBY/DTS/MPEGPress Test to check the speaker JVC Theater Surround adjustmentsRepeatedly until Theater or DIG Theater appears on DisplayPress Surround ON/OFF so Activating the DSP ModesLamp on the button lights up Select and play a sound sourceFor the other DSP modes Mode you want appears on DisplayTo cancel the DSP mode Press Surround Mode repeatedly untilTone appears on the display Using the DVD Multi Playback ModeActivating the DVD Multi Playback Mode DVD Multi appears on DisplayPress DVD Multi so that DVD 10 keys are activated for adjusting the soundMulti appears on the display Using the On-Screen Menus Loudness on or Input Attenuator modeTo Loudness Press @/ #to turnCreating Your Own SEA Mode To SEA ModeActivating the DVD Multi Playback Mode Selecting Your Favorite SEA ModeSetting the Basic Setting Items Also see Press %/ Þ/ @/ #to adjust the SEA mode as you wantPress SET to store the setting into the SEA Usermode Press %/ Þto move to SETTING, then Press @/ #Press %/ Þ / @/ #to Move in front of a character you want Press %/ Þto move to Preset Name Then press SETPreset station number Press %/ Þto move to Tuner CONTROL, then press @/ #Automatic Source Selection Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Same timeDisc Search Only for CD Player Text Compu Link Remote Control SystemCD player MD recorder Displaying the Disc Information on the TV screenDisc Information screen appears on the TV Press Text Display while CD or MD is selected as the sourceShowing the Disc Information on the TV Screen To exit from the Disc information screenPress SET again Press Text Display while CD is selected as the sourcePress %/ Þto move to SEARCH, then Press SET Press %/ Þto move To Performer Then press SETEntering the Disc Information Press %/ Þto move to Search Then press SETPress %/ Þto move To GENRE, then Press SET Press %/ Þto move To Title INPUT, then press SETTo correct an incorrect character Press Text Display while MD is selected as the sourcePress %/ Þto move to the genre you want, then press SET To insert a space, press %/ ÞCD player-changer Tuner Operating JVC’s Audio/Video ComponentsSound control section Amplifier CD playerDVD player TurntableCassette deck MD recorderTry to operate your TV by pressing TV/CATV DBS If there are more than one code listed for your brand of TVOperating Other Manufacturers’ Video Equipment Release TV/CATV/DBSRelease VCR If there are more than one code listed for your brandTry to operate your VCR by pressing VCR Manufacturers’ codes for TV Manufacturers’ codes for DBS tuner Manufacturers’ codes for Catv converters SEI Problem Possible Cause Solution TroubleshootingAmplifier SpecificationsVideo General Tuning Range Usable Sensitivity Signal-to-Noise RatioFM tuner IHF AM tunerPrecaução para a ligação à tensão da rede CA Precaución para la línea de la red CA