JVC RX-DP9VBK manual Front door while viewing, Picture from a video component

Speaker and signal indicators on the display

By checking the following indicators, you can easily confirm which speakers you are activating and which signals are coming into this receiver from the source.

Selecting different sources for picture and sound

While watching pictures from a video source, you can listen to sound of a different source.

Speaker indicators

L C R

SUBWFR

LS RS

SB SB

Signal indicators

L C R

LFE

LS S RS

SB SB

On the unit:

You can select any component as the sound source.

1. Press SOUND SELECTOR (inside
		SOUND
	the front door) while viewing the		SELECTOR
	picture from a video component
	such as the VCR or DVD player, etc.
	ANALOG		SPEAKERS 1
	L R
			VOLUME

The speaker indicators light only —:

•The frames of “L,” “C,” “R,” “LS,” “RS, ” and “SB” light up, when the corresponding speakers are set to “LARGE” or “SMALL ” (see “Setting the Speakers—SPEAKER SETTING” on page 29) AND when the corresponding speaker is required for the DSP mode currently selected.

•When “SUBWOOFER” is set to “YES,” SUBWFR lights up. (See “Setting the Speakers—SPEAKER SETTING” on page 29.)

The signal indicators light up to indicate the incoming signals.

L: • When digital input is selected: Lights up when the left channel signal comes in.

•When analog input is selected: Always lights up.

R: • When digital input is selected: Lights up when the right channel signal comes in.

•When analog input is selected: Always lights up.

C: Lights up when the center channel signal comes in. LFE : Lights up when the LFE channel signal comes in.

LS : Lights up when the left surround channel signal comes in.

RS : Lights up when the right surround channel signal comes in.

S : Lights up when the monaural surround channel signal comes in.

SB : Lights up when the surround back channel signal comes in.

Note:

When “DVD MULTI” is selected as the source, “L,” “C,” “R,” “LFE,” “LS” and “RS” light up.

To obtain the best performance of this receiver while using the

Surround/DSP modes, check the speaker and signal indicators on the display carefully and set the speakers correctly.

L	C R	Ex. No sound comes out of the
SUBWFR LFE		center speaker and surround
		back speakers though center
LS	RS	channel and surround back
		signals are coming into this
SB	SB	receiver.

SUBWFR

dB

“AUDIO” appears followed by the current sound source.

Within

5seconds

2.Press one of the source selecting buttons.

DVD DVD MULTI VCR 1 VCR 2 TV/DBS VIDEO CD PHONO TAPE/MD CDR FM AM

Note:

When “TV” has been assigned as the source name to the TV/DBS button, it does not work. To change the source name, see “Changing the Source Name” on page 22.

To match the video source and sound source again, repeat steps 1 and 2, and select the same sound source as the video source in step 2.

From the remote control:

You can select only audio component as the sound source when using the remote control.

•Once you have selected a video source, pictures of the selected source are sent to the TV until you select another video source.

Press one of the audio source selecting buttons— PHONO, CD, TAPE/MD, CDR, FM, AM—while viewing the picture from a video component such as the VCR or DVD player, etc.

DVD	DVD MULTI	PHONO	CD
VCR 1	VCR 2	TAPE/MD	CDR
TV/DBS	VIDEO	FM	AM

18