Reinstall the Bracket Cover

Cardio Theater Integrated Bracket Assembly Instructions

6 Reinstall the Bracket Cover

1.Prepare the fasteners for reinstalling the bracket cover.

Push the washers and bearings toward the bolt heads so there is room for the bracket cover to slide in flush against the pivot tube.

Important: Keep the bracket cover flanges flush with the pivot tube. The washers and bearings need to remain on the outside of the bracket flanges.

2.Hold the bracket cover above the pivot tube. Apply pressure to the top of the bracket cover while you slide it into position.

3.Tighten the two top screws on the back of the LCD Screen.

Use a Phillips-head screwdriver to fully tighten the top two screws on the back of the LCD Screen. Access holes have been drilled through the bracket cover.

4.Secure the bracket cover.

Using a torque wrench and a ⁷⁄₃₂-inch hex key, retighten the two pivot tube fasteners to 120 in-lbs.

1	2	Top of bracket cover
Bracket
cover
Pivot tube
3
Bracket cover	4
		Pivot tube

page 14