Cardio Theater Integrated Bracket Assembly Instructions
6.Feed the coaxial/power cable and its connectors through the upright support.
Ask your assistant to hold the bracket assembly close while you insert the cable and its connectors into the upper hole on the upright support. Slide the cable down until you can access the connectors through the lower hole.
Note: You may need to move the ribbon cable inside the upright support to gain clear access.
7.Pull the cable and its connectors out of the lower hole. If needed, use a
Note: While you pull about 3 feet (1 meter) of cable out of the lower hole ask your assistant to align the bracket assembly with the mounting fasteners on the upright support. Make sure the bracket assembly slides into place along the outside of the upright support.
8.Attach the bracket assembly and replace the fasteners.
Ask your assistant to continue holding the bracket assembly, while you replace the three fasteners removed in step 4. Securely tighten all three screws using a
6 |
|
8 | Display console |
| |
| Bracket assembly |
Upright support |
|
7 |
|
| Rubber boot |
| Coaxial/power cable |
| (with coaxial and power connectors) |
Install the Bracket Assembly
page 8