Razor 360 Assembly and SET-UP, Attaching the Front Fork, Attaching the Pedals and Front Wheel

ASSEMBLY AND SET-UP

❑Attaching the Front Fork

1 Remove the steering bolt and	2 Insert the front fork assembly	3 Be sure to align slot in headset
locknut from the frame assembly	into the frame assembly.	tube with pin on fork properly as
with a 13mm open wrench and		shown.
5mm hexagonal wrench.

4Re-insert the steering bolt and secure with locknut using a 13mm open wrench and 5mm hexagonal wrench.

❑Attaching the Pedals and Front Wheel

WARNING: Failing to properly tighten the steering bolt that attaches the handlebar can cause you to lose control and fall.

WARNING: Failing to install the correct pedal on the correct crank (left and right) can cause the pedal to strip.

1 Install the left pedal into the crank marked (L). Tighten with 15mm open end wrench. Repeat step for right pedal and crank.

4Re-insert the Allen socket screws through the front fork and secure with nuts. Tighten nuts with a 10mm open wrench and 5mm hexagonal wrench.

2 Remove the four Allen socket	3 Insert the wheel assembly into
screws and nuts from the front	the front fork assembly and align
fork with a 10mm open wrench	holes.
and 5mm hexagonal wrench.	Note: Refer to R (right) and L (left)
	stickers on pedals for orientation.

3