Razor 360 owner manual Attaching the Rear Caster Wheels, Attaching the Seat

1 Insert large spacer into wheel

2 Insert one small spacer between

3 Insert Allen socket screw

and insert bearings into each side

wheel and caster and align holes.

through caster, small spacer and

of wheel. Make sure all holes are

Insert axle bolt through caster, small

into axle bolt. Tighten with 5mm

aligned. Insert wheel into caster.

spacer, wheel and into small spacer

hexagonal wrench on both sides.

on other side of wheel.

4 Locate the threaded hole

5 Tighten with 5mm hexagonal

on the rear underside of frame.

wrench.

Screw caster wheel into hole.

1 Remove the four Allen socket

2 Align four holes in seat with

3 Secure with Allen socket

screws and Allen long screws

four holes in frame. Insert Allen

screws. Tighten screws with two

from the frame with two 5mm

long screws through the bottom of

5mm hexagonal wrenches. One on

hexagonal wrenches. One on top

the frame.

top and one on bottom.

and one on bottom.