Assembly
5
.437 Cap Nut
.437"
Lower Shock Rod
.437 Cap Nut
7 Rear of Vehicle Frame
Narrow End
of Monoshock
Hole
•Place a .437 cap nut on a flat surface, inside up, as shown.
Hint: You may want to place a scrap block of wood underneath the cap nut to protect the assembly surface.
•Fit the lower shock rod into the cap nut.
•Tap the opposite end of the lower shock rod with a hammer to secure the cap nut on the lower shock rod. Pull on the cap nut to be sure it is secure.
6 |
Moveable |
Top Piece |
Lift |
Right Side View |
• Lift the moveable top piece of the vehicle frame.
Top View
Note: The illustration above does not show the moveable top piece of the vehicle frame.
•Insert the narrow end of the monoshock into the hole in the top of the frame, as shown.
8
Monoshock
Axle Guide | Axle Guide |
Top View
•Turn the monoshock so the bottom fits into the axle guides
11 inside the frame.