Battery Charging
1
Plastic Retainer
Battery
Plastic Retainer
•Using safety scissors, cut the plastic retainers holding the battery in the packaging.
•Remove the battery from the packaging.
•Throw the packaging and plastic retainers away.
2
Battery
Charger
Connector
•Plug the charger connector into the battery 
.
•Plug the charger into a standard 120 volt wall outlet 
.
Note: If power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”.
•Before
•Recharge the battery for at least 14 hours after each use of your vehicle. Do not charge the battery longer than 30 hours.
•Once the battery is charged, pull firmly on the charger connector to disconnect it from the battery. Unplug the charger from the wall outlet. The battery is now ready to be installed in your vehicle. Please see the Battery Installation section on page 24 for detailed instructions on installing your battery. If your battery is already installed in your vehicle, simply plug the motor harness connector into the battery and replace the seat.
9