Assembly
26 | Battery |
Compartment | |
| Door |
| Battery |
| Compartment |
27
.354 Cap Nut
.354"
Fork Axle
.354 Cap Nut
1.5V x 3 |
“AA” (LR6) |
SHOWN ACTUAL SIZE
•Place the handlebar assembly face down on a flat surface.
•Loosen the screw in the sound box battery compartment door using a Phillips screwdriver and open the battery compartment.
•Insert three “AA” (LR6)alkaline batteries in the sound box as indicated in the battery compartment.
Hint: For longest battery life, use only alkaline batteries.
•Close the battery compartment door and tighten the screw using a Phillips screwdriver. Do not
Battery Tips
•Do not mix old and new batteries.
•Do not mix different types of batteries: alkaline, standard
•Remove the batteries during long periods of
•Never short circuit the battery terminals.
•
• Place a .354 cap nut on a flat surface, inside up, as shown.
Hint: You may want to place a scrap block of wood underneath the cap nut to protect the assembly surface.
•Fit the fork axle into the cap nut.
•Tap the opposite end of the fork axle with a hammer to secure the cap nut in the fork axle. Pull on the cap nut to be sure it is secure.
28 |
|
Curved Slot |
|
Steering Stop | Tab |
|
•Only batteries of the same or equivalent type as recommended in these instructions are to be used.
•If removable rechargeable batteries are used, they are only to be charged under adult supervision.
•Rechargeable batteries are to be removed from the sound box before they are charged.
•If you use a battery charger, it should be examined regularly for damage to the cord, plug, enclosure and other parts. Do not use a damaged battery charger until it has been properly repaired.
•When sound from the vehicle becomes faint, or if the sound stops working, it’s time to replace the batteries.
•Fit the tab on the steering stop into the curved slot in the front end of the vehicle frame.
•Hold the steering stop in place.
17