Huffy M0012 manual Assembly Pedal Installation, Tighten the pedals ﬁg

Page 18

Assembly

Pedal Installation

CAUTION: There is a right pedal marked “R” and a left pedal marked “L”.

•The pedal marked “R” has right-hand threads. Tighten it in a clockwise direc- tion.

•The pedal marked “L” has left-hand threads. Tighten it in a counterclockwise direction (anti-clockwise).

•Turn the right pedal marked “R” into the right side of the crank arm, and the left pedal marked “L” into the left side of the crank arm.

Tighten the pedals (ﬁg 09):

•Make sure the threads of each pedal are fully into the crank arm.

•Make sure pedals are fully tightened with wrench.

NOTE: The recommended torque (tightness) for each pedal is 30 ft.-lbs.

L

R

fig 09

Note: A Pedal Wrench is preferred for attaching Pedals. An open-end

wrench can also be used as shown.

WARNING: Ensure pedals are secure in crank arms so they will not loosen. Periodically check tightness.

18

Image 18

Contents For Mountain Bikes Your Bike Owner’s Bicycle Identiﬁcation Record Fitting the Rider to the Bicycle Your BikeModel / Serial Number Purchase Date Model Name If you must ride at night or at time of poor visibility Rules of the RoadMeanings of Warnings Use extra caution in wet weatherYour Bike Owner’s Responsibility Parts Assembly View Parts View Parts Assembly List Parts ListDescription Assembly Introduction Tools Needed AssemblySmall Adjustable Wrench Flat-blade ScrewdriverHandlebar and Stem Installation Quill Style StemThreadless Style Stem Assemble the Front Wheel to the Fork Assembly Install the Front WheelLoosen the Front Brakes Re-attache Front Brake Cable Re-attach Front Brake CableAssembly Setting Up the Handlebars Testing Stem and Handlebar Tightness To test the tightness of the stemTo test the tightness of the handlebar clamp Assembly Seat Installation Attach Seat to Seat Post pre-assembled on some modelsTighten the quick release lever If the seat moves in the Seat Clamp a ﬁg Testing Seat Clamp and Post Clamp TightnessTo test the tightness of the seat clamp and the post clamp If the Seat Post 9 moves in the Seat Tube BAssembly Pedal Installation Tighten the pedals ﬁgReﬂector Brackets Installation Installing Derailleur Guard on some modelsMaintenance Brake System Test the tightness of each Brake ShoeCheck tightness of the cantilever mounting Bolt a Maintenance Final Brake Adjustment Before RidingStretching the cable ﬁg Center brake shoes on rimMaintenance Final Brake Adjustment Put the brake shoes the correct distance from the rimMaintenance Test the tightness of the cable clamp ﬁgTest the travel of each brake lever Maintenance Shift System Parts of the Shift SystemOperation Operate the shift system as follows Maintenance Shift System These are the higher gear combinations Front Derailleur Adjustments Perform the Rear Derailleur Adjustments if Maintenance Rear Derailleur Adjustments Adjust the Index Shift System ﬁg Maintenance Three-Piece Cranks various models MaintenanceAdjustment Suspension Frame various modelsTo change the suspension Maintenance Tires Inﬂating the TiresRepair and Service Maintenance LubricationWhat When How Lubrication TableHead Tube Bearings Maintenance ReﬂectorsInspection of the Bearings Crank BearingsWhat must you do to keep the Limited Warranty in effect? Warranty Huffy Corporation Limited WarrantyWhat does this Limited Warranty cover? What is not covered by this Limited Warranty?How do you get service? WarrantyFor how long does this Limited Warranty last? What will Huffy do?Always Wear Your Helmet When Riding this Product