Huffy 1C4880-A01 manual Bottom of Fork, Handlebar Mount Style 1 and Style

Bottom of Fork

1.Attach the hardware to the fork:

-Remove and discard plastic cap [5] on fork [6]

-Tighten bearing cone [2] by hand to make sure the bearings are tight

-Install sheath stop [3] and locknut [4]. You may not have a sheath stop. If you do not, install a keyed washer and locknut.

NOTE: The sheath stop barrel [11] is on the cable wire of the front cantilever brake. Install it during the assembly of the brake.

-Tighten locknut.

2.Assemble the front reflector bracket and clear reflector to the fork:

-Attach the reflector bracket to the front of the fork with a bolt [9] and self locking nut [10]

-If necessary, adjust the angle of the front reflector bracket so the clear reflector is vertical (perpendicular to the ground).

Handlebar Mount - Style 1 and Style 2

1.Assemble to the handlebar:

-Put the clamp [1] as near the handlebar stem as possible

NOTE: If you have Style 1, make sure the bracket points towards the ground.

- Hold the reflector in this position and tighten the screw(s) [3].

Operation and Maintenance

WARNING: For your own safety, do not ride the bicycle if the reflectors are incorrectly installed, damaged, or missing. Make sure the front and rear reflectors are vertical. Do not allow the visibility

of the reflectors to be blocked by clothing or other articles. Dirty reflectors do not work well. Clean the reflectors, as necessary, with soap and a damp cloth.