Seat
Assembly
CAUTION: If you accidently drop the seat post 
into the seat tube, you may not be able to remove it.
1. Install post clamp on seat tube:
-Put the clamp on the seat tube. Push the clamp
[1]down so you can see 1/16 inch [2] of the seat tube
[3]above the clamp.
NOTE: Some post clamps are welded in position and can not be moved.
-If the post clamp has a raised edge, make sure the raised edge is against the top of the seat tube.
2.Assemble the seat to the seat post or seat pillar:
The bicycle may have a seat post or seat pillar. Determine which style you have and follow the instructions.
Seat Post Style
-Put the seat post [10] fully through the seat clamp [11]
-Tighten the seat clamp so the seat [12] stays on the seat post
-If the seat clamp has a nut on each side, tighten both nuts equally
Seat Pillar Style
-If the seat has a clamp attached, remove and discard the clamp
-Put the seat rails [ ] between the seat clamp and tighten the clamp.