Huffy 1C4880-A01 manual

Page 8

3.Assemble the quick release mechanism to the front wheel:

-Remove the adjusting nut [4] and one spring from the quick release mechanism

-Put the quick release mechanism through the front wheel hub

-Put the spring and adjusting nut back on the quick release mechanism

-Do not tighten the adjusting nut at this time.

4.Assemble the front wheel to the fork:

NOTE: The words “open” and “close” are on opposite sides of the quick release lever.

-Move the quick release lever [1] to the “open” position [2] so the word “open” is pointing away from the wheel

-Put the wheel between the fork legs [3]. Make sure the axle is against the bottom of the slot in each fork leg.

Image 8

Contents Multi Speed Bicycles HBC Limited Warranty Owner’s Bicycle Identification Record Safety InformationMeanings of the Safety Instructions Fitting the Rider to the Bicycle Rules of the RoadOwner’s Responsibility Page Introduction Tools NeededFront Wheel Page Page Operation Screw In Style Front Reflector Bracket and Clear Reflector AssemblySnap In Style Front Reflector Bracket Installation Top of ForkBottom of Fork Handlebar Mount Style 1 and StyleRear Reflector Bracket and Red Reflector Assembly Post Clamp Rear Reflector Bracket InstallationSeat Post Style 1 Bolt and nut Spoke ReflectorsRear Brace Operation and Maintenance Assembly Handlebar and StemInside mount style Outside mount styleThumb Shift Page Operation Seat Pillar Style SeatSeat Post Style Page Operation and Maintenance Pedals Adjustments Brake SystemsSidepull Brake Cantilever Brake Page Reducing Caliper Brake Noise Caliper Brake Only Operation Bags AccessoriesWater Bottles Saddle Bag Handlebar BagFrame Bag Rear Mount KickstandCrank Mount Shift System General Adjustments Rear Derailleur Adjustments Chain Suspension Frame on some models Repair and ServiceAdjustments Tires MaintenanceThree-Piece Cranks on some models What When How LubricationInspection of the Bearings Head Tube BearingsCrank Bearings Wheel BearingsReplacement Part Order List