Assembly
11 | Front Wheel Assembly | Fork Arms | 13 | Pegs |
|
|
Seat
Fork Cover
Holes
Groove
Pedal Axle | #8 x 3/4" Screw – 4 |
| SHOWN ACTUAL SIZE |
•Place the front wheel assembly between the fork arms so that the pedal axle fits into the groove at the bottom of each fork arm.
•Place a fork cover over the pedal axle on one fork arm.
•Insert two #8 x 3/4" screws into the fork cover and tighten with a Phillips screwdriver. Do not
•Repeat this procedure to attach the other fork cover to the other fork arm.
Handlebar 
•At an angle, insert one peg on the back of the seat into the hole in the rear of the frame.
•Insert and "snap" the other peg on the back of the seat into the other hole in the rear of the frame.
One-time assembly is now complete.
12
Frame Neck
Fork Post
Fork Cover
#8 x 3" Screw – 1 |
SHOWN ACTUAL SIZE |
•Turn the frame upright.
•Insert the fork post up through the hole in the neck of the frame. Make sure the fork is positioned so that the fork covers face the rear wheels.
•Place the handlebar over the fork post and push it down onto the frame. Make sure the handlebar is positioned so that the screw hole faces the rear wheels and aligns with the screw hole in the fork post.
Hint: You may need to rotate the handlebar to align the holes.
•Insert the #8 x 3" screw through the hole in the han- dlebar and into the fork post. Tighten the screw with
a Phillips screwdriver. Do not | 5 |