JVC RX-7001PGD manual Using the DVD Multi Playback Mode, Activating the DVD Multi Playback Mode

English

Using the DVD MULTI Playback Mode

This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD player. Before playing back a DVD, refer also to the manual supplied with the DVD player.

IMPORTANT:

When using the remote control, check to see if its

remote control mode selector is set to the correct	AUDIO/
	TV/VCR
position:
To operate this receiver, set it to “AUDIO/TV/	CATV/DBS
VCR.”

Activating the DVD MULTI Playback Mode

You can adjust the DVD MULTI playback mode while playing back a DVD using the analog discrete output mode on the DVD player. Once you have made adjustments, the receiver memorizes the adjustments until you change them. You also need to set the DVD player to the analog discrete output mode.

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel:

1. Turn SOURCE SELECTOR until	SOURCE SELECTOR
“DVD MULTI” appears on the
display.

Note:

When you select “DVD MULTI” as the source to play, the DSP mode is canceled temporarily, and the SURROUND ON/OFF and DSP MODE buttons do not work.

2.Select the analog discrete output mode on the DVD player, and start playing a DVD.

• Refer to the manual supplied with the DVD player.

If you need to make any adjustment, go to the following steps.

From the remote control:

1. Press DVD MULTI so that “DVD	DVD MUILTI
MULTI” appears on the display.

Note:

When you select “DVD MULTI” as the source to play, the DSP mode is canceled temporarily, and the SURROUND ON/OFF and SURROUND MODE buttons do not work.

2.Select the analog discrete output mode on the DVD player, and start playing a DVD.

• Refer to the manual supplied with the DVD player.

If you need to make any adjustment, go to the following steps.

SOUND

3. Press SOUND.

The 10 keys are activated for adjusting the sound.

4.Adjust the speaker output levels.

•To adjust the center speaker level, press CENTER –/+ (from – 10 dB to +10 dB).

•To adjust the left rear speaker level, press REAR•L –/+ (from –10 dB to +10 dB).

•To adjust the right rear speaker level, press REAR•R –/+ (from –10 dB to +10 dB).

CENTER REAR•L REAR•R

2 3 5 6 8 9

MENU ENTER

3.Adjust the speaker output levels.

1)Press (BALANCE/) SURROUND ADJUST repeatedly until one of the indications appears on the display. “CENTER LEVEL”:

To adjust the center speaker level. “REAR L LEVEL”:

To adjust the left rear speaker level. “REAR R LEVEL”:

To adjust the right rear speaker level.

2)Turn MULTI JOG to adjust the selected speaker output level (from –10 dB to +10 dB).

3)Repeat 1) and 2) to adjust the other speaker output levels.

BALANCE/SURROUND

ADJUST

MULTI JOG

29