Huffy M730131 manual 16 1/2 9/16 3/4

Page 13

SECTION B: ATTACH THE BACKBOARD

This is what your system will look like when you’ve finished this section.

ITEMS REQUIRED FOR THIS SECTION

(2) 7/16", (2) 1/2", (2) 9/16" AND (2) 3/4" Wrenches

AND/OR

(2) Socket Wrenches and Sockets

7/16” 1/2” 9/16” 3/4”

1. Fit spacer (33) into pawl (27). Then continue to

assemble as shown. Tighten completely.

IMPORTANT!

Test fit bolts into holes of backboard brackets (29) and carefully rock them in a circular motion to ream out paint from holes if necessary.

29

33

34

35

14

9

33

27

13

11/05

ID# M730131

Image 13
Contents Portable Basketball System Safety Instructions Height Adjustment Before YOU Start Get to know the basic parts of your basketball system Hardware Identifier Bolts and Screws Hardware Identifier Nuts and Washers Section a Assemble the Base Align dimple of top pole into trough of middle pole as shown Pole Sections should have a 3-1/2 9 CM Minimum Overlap Do not Over Tighten Tighten Bolt 11 in Lock 16 1/2 9/16 3/4 Elevator Tubes USE EYE Protection ID# M730131 11/05 11/05 ID# M730131 If Using Sand Do not Allow