Huffy M730131 manual Height Adjustment

Page 3

25

HEIGHT ADJUSTMENT

WARNING

Read and understand warnings listed below before using this product.

Failure to follow these warnings may result in serious injury and/or property damage.

Owner must ensure that all players know and follow these rules

for safe operation of the system.

DO NOT HANG on the rim or any part of the system including

 

backboard, support braces or net.

During play, especially when performing dunk type activities,

 

keep player's face away from the backboard, rim and net.

 

Serious injury could occur if teeth/face come in contact with

 

backboard, rim or net.

Do not slide, climb, shake or play on base and/or pole.

After assembly is complete, fill system completely with water

 

or sand and stake to the ground. Never leave system in an

 

upright position without filling base with weight, as system

TO ADJUST BACKBOARD:

1.TO RAISE BACKBOARD:

Slowly push up on the rim with broom handle or wooden dowel,

3/4”- 7/8” (19mm - 22mm) diameter as shown to engage locking mechanism at desired height.

2. TO LOWER BACKBOARD: Push lever up to unlock and carefully lower backboard to lowest position.

LEVER

BROOM HANDLE

1

2

 

may tip over causing injuries.

When adjusting height or moving system, keep hands and

 

fingers away from moving parts.

Do not allow children to move or adjust system.

During play, do not wear jewelry (rings, watches, necklaces,

 

etc.). Objects may entangle in net.

Surface beneath the base must be smooth and free of gravel or

 

other sharp objects. Punctures cause leakage and could cause

 

system to tip over.

Keep organic material away from pole base. Grass, litter, etc.

 

could cause corrosion and/or deterioration.

Check pole system for signs of corrosion (rust, pitting,

MOVING SYSTEM

chipping) and repaint with exterior enamel paint. If rust has

penetrated through the steel anywhere, replace pole

immediately.

1

3

4

1.Adjust basketball backboard height to lowest position.

2.While holding pole, rotate basketball system forward until wheels engage with

ground.

3. Move basketball system to desired location.

2

4. Carefully rotate basketball system upright.

5. Reattach ground restraint and check system for stability.

Check system before each use for proper ballast, loose

 

hardware, excessive wear and signs corrosion and repair

 

before use.

Check system before each use for instability.

Do not use system during windy and/or severe weather

 

conditions; system may tip over. Place system in the storage

 

position and/or in an area protected from the wind and free

 

from personal property and/or overhead wires.

Never play on damaged equipment.

See instruction manual for proper installation and

 

maintenance.

When moving system, use caution to keep mechanism from

 

shifting.

Keep pole top covered with cap at all times.

201257 3/99

Do not allow water in tank to freeze. During sub-freezing

 

weather add 2 gallons of non-toxic antifreeze, sand or empty

 

tank completely and store. (Do not use salt.)

While moving system, do not allow anyone to stand or sit on

 

base or have added ballasting on base.

Do not leave system unsupervised or play on system when

 

wheels are engaged for moving.

Use Caution when moving system across uneven surfaces.

 

System may tip over.

Use extreme caution if placing system on sloped surface.

 

System may tip over more easily.

 

 

In the U.S.: 1-800-xxx-xxxx

In the U.S.: 1-800-xxx-xxxx

Canada: 1-800-xxx-xxxx

Canada: 1-800-xxx-xxxx

In the U.S.: 1-800-xxx-xxxx

In the U.S.: 1-800-xxx-xxxx

Canada: 1-800-xxx-xxxx

Canada: 1-800-xxx-xxxx

ID#: 556790 01/05

3

11/05

ID# M730131

Image 3
Contents Portable Basketball System Safety Instructions Height Adjustment Before YOU Start Get to know the basic parts of your basketball system Hardware Identifier Bolts and Screws Hardware Identifier Nuts and Washers Section a Assemble the Base Align dimple of top pole into trough of middle pole as shown Pole Sections should have a 3-1/2 9 CM Minimum Overlap Do not Over Tighten Tighten Bolt 11 in Lock 16 1/2 9/16 3/4 Elevator Tubes USE EYE Protection ID# M730131 11/05 11/05 ID# M730131 If Using Sand Do not Allow