Insert the Barbell (35) through the locking Bar (34) until the Barbell Is centered in the Locking Bar.
9.Identify the Left Weight Glider (32) by looking at the position of the round tube.
Press a 38ram Bushing (29) into each end of the round tube on the Left Weight Glider (32).
Slide the Left Weight Glider (32) onto the left end of the Barbell (35). Secure the Weight Glider to the Barbell with a
10.Identify the Right Weight Glider (31) by looking at the position of the round tube.
Press a 38mm Bushing (29) into each end of the welded tube on the Right Weight Glider (31).
Slide the Right Weight Glider (31) onto the right end of the Barbell (35). Secure the Weight Glider to the Barbell with a
Make sure that the Weight Glider is turned as shown in the drawing.
11.Note: If you are not planning to use Olympic weights with the weight bench, you do not need to perform this step. Keep the two Weight Adapters (33) in a safe place in case you need them in the future.
Slide a Weight Adapter (33) onto one end of the Barbell (35). Using the allen wrench, secure the Weight Adapter with an MIO x 25mm Bolt (43) and a Large Washer (44). Note: The Large Washer must fit into the indentation in the 50ram Bushing (47) in the Weight Adapter.
Attach the other Weight Adapter (33) to the other end of the Barbell (35) in the same manner•
9
29 32
355O
29
Round tube
10
o
11
35
33
47
44 / | /" |
| 43 |
9