Left Safety Spotter is positioned as shown,thehandle. will point toward the center of the bench.
Place the Left Safety Spotter (24) on the left Base (7) so it is centered over the indicated hole.
Have a second person hold the Locking Bar (34) so that the Left Weight Glider (32) rests on top of the Left Safety Spotter (24)..Insert a Weight Guide (18) into the Left Weight Glider, the Left Safety Spotter, and the hole in the Base (7). Note: It may be neces- sery to tilt the Weight Guide away from the Upright (1) as you insert it.
Attach the Weight Guide (18) to the Base (7) with an M8 x 60ram Bolt (39), two M8 Washers (52), and an M8 Nylon Locknut (54). Do not tighten the Nylon Locknut yet.
13.Place the Right Safety Spotter (23) on the right Base
(7)and center it over the indicated hole. Note: The handle must point toward the center of the bench.
Have a second person hold the Locking Ba_ (34) so that the Right Weight Glider (31) rests on top of the Right Safety Spotter (23). Insert a Weight Guide (18) into the Right WeightGlider, the Right Safety Spotter, and the hole in the Base (7). Note: It may be neces- sary to tilt the Weight Guide away from the Upright (1) as you insert it.
Attach the Weight Guide (18) to the Base (7) with an M8 x 60mm Bolt (39), two M8 Washers (52), and an M8 Nylon Locknut (54). Do not t!ghten the Nylon
Locknut yet.
14.Attach the upper end of one of the Weight Guides
(18)to the bracket on the Upright (1) with an M8 x 30mrfi Belt (38) and an MB Washer (52).
Attach the other Weight Guide (18) to the other Upright (1) in the same manner.
Tighten the M8 x 16ram Screws (50) used in steps 9to 10.
Tighten all of the Nylon Locknuts used in steps 1 to 14.
34
Hole
52 39
13
39 23\
10 | _" |