Attach the Small | Stabilizer (25) to the Bench Frame | •.. | 11 | i//_r | 5 | " | " |
A | I 11- - |
|
| ||||
(5) with two M10 | x 65mm Cardage Bolts (40) and two | "_A |
|
|
|
| |
M10 Nylon Locknuts (11). Note: There is an inden- | _ |
| _'1 iI |
|
|
| |
tation around the holes on one side of the Small |
| '4f |
|
|
| ||
Stabilizer. This | side must be facing the floor. |
| _._'_'_"_ |
| 25 |
|
40J_J
16. Press a 50mm x 70mm Outer Cap (10) onto each |
end of the Large Stabilizer (26). |
Turn the Large Stabilizer (26) so the warning decal is |
in the position shown. Attach the Large Stabilizer to |
the Bench Frame (5) with two M10 x 65ram Carriage |
Bolts (40) and two M10 Nylon Locknuts (11). Note: |
There is an indentation around the holes on one |
side of the Large Stabilizer. This side must be fac- |
ing the floor. |
17. Press two 20mm x 40ram Inner Caps (28) into each |
Backrest Tube (27). Press four 20mm x 40ram Inner |
Caps into the Backrest Adjustment Bracket (36). |
Lubricate an MIO x 180mm Bolt (22). Attach the |
Backrest Tubes (27) to the welded tube on the |
Backrest Adjustment Bracket (36) with the Bolt, two |
M10 Washers (6), and an M10 Nylon Locknut (11). |
Make sure that the Backrest Tubes are turned as |
shown. The indicated holes are not centered in |
the Backrest Tubes but are closer to one side. |
Turn the Backrest Tubes so the holes are closer |
to the floor. Do not overtighten the Nylon Locknut; |
the Backrest Tubes must pivot easily. |
18. Attach the Backrest Adjustment Bracket (36) to the |
bracket on the Bench Frame (5) in the following way: |
Lubricate an M10 x 115mm Bolt (55). Slide an M10 |
Washer (6) onto the Bolt and insert the Bolt through |
16
Decal
10
|
|
| 40 |
17 | Lubricate | 27 | 28 |
|
| ||
22_ | \ | 6 |
|
28
Wel
Tube 36
1827
the indicated tube of the Backrest Adjustment Bracket |
(36). |
Hold the Backrest Adjustment Bracket (36) over the |
bracket on the Bench Frame (5). Insert the Bolt |
through one side o1 the bracket. Slide the 15mm x |
10.2mm x 60mm Spacer (57) onto the Bolt. Next, |
insert the Bolt through the other side of the bracket |
and the other tube of the Backrest Adjustment |
Bracket. Secure the Bolt with an M10 Washer (6) and |
an M10 Nylon Locknut (11). Do not overtighten the |
Nylon Locknut. |
55
Lubricate
36
11