Fisher & Paykel GC912M, GC36 manuel dutilisation Trouble shooting, Problem Possible solutions

Trouble shooting

Problem	Possible solutions
My cooktop does not	Check it is plugged in and there is power to the wall socket.
light	The gas igniters may be dirty. These can be easily cleaned
	with a toothbrush and rubbing alcohol.
	The burner parts may not be located properly. Check the
	assembly and make sure the burner cap is sitting flat.
	Check the gas supply valve is turned on and the supply to
	the house is working. Gas should be heard when you turn a
	burner on.
My burner flames are	The burner parts may not be located properly. Check the
yellow/slow to start	assembly and make sure the burner cap is sitting flat.
	If you use bottled gas this may indicate you are getting near
	the end of the bottle.
	Check that the burner parts are not blocked with water.
	The gas pressure may not be correct, check with your service
	person/installer.
One of my burners has	Check the burner parts are assembled correctly and that the
an uneven flame	burner cap is sitting flat on the burner.
My cooktop is sparking	Your cooktop thinks that the flame has gone out. This could
	be caused by drafts disturbing the flame e.g. using a down
	draft.
	Check that the igniter is clean and dry.
	Your power supply may not be properly grounded or, in an
	older house, the correct wiring polarity may not have been
	observed.
The flame goes out at	Gas supply pressure may be low, check with service person/
low settings	installer.
	Low setting may be incorrect, check with your service person/
	installer.

14