Cisco Systems 11000 Series Troubleshooting the CSS 11800 Modules, Symptom Recommended Action

Chapter 2 Cabling the CSS

Troubleshooting CSS Hardware Components

Note Installing a second CSS 11800 power supply provides power load balancing between the two power supplies. When you install a second power supply, it powers on and begins to share the power load automatically.

Troubleshooting the CSS 11800 Modules

Each CSS 11800 module is equipped with a temperature sensor that detects an over- or under-temperature condition. If the module detects that its temperature is out of range, it generates a log message.

Module status is indicated by the Status LED on the module front panel. For information about the module LEDs, see the module information earlier in this chapter.

Table 2-15 provides suggestions for correcting problems that may occur with the modules.

Table 2-15 Troubleshooting the CSS 11800 Modules

Symptom	Recommended Action
System cannot identify	Remove the module and re-install it to reseat the
module type.	module in the backplane connector.
	Reload the ADI file.
System cannot find an image	Reload the ADI file.
for the module.
Module failed diagnostic	Replace the module.
(according to the
information in the Boot.log
file).

	Cisco 11000 Series Content Services Switch Hardware Installation Guide
78-15146-02		2-37