
Chapter 1 Unpacking and Installing the CSS
Installing a CSS 11800 Module
3.Insert the module into the board guides at the top and bottom of the slot and slide it into the chassis by pressing firmly at the top and bottom of the faceplate as shown in Figure
Figure 1-8 Installing a Module into a CSS 11800 Chassis
49573
4.Close both ejectors simultaneously to seat the module connector into the backplane.
5.Using a Phillips screwdriver, tighten the
If you installed a SFM or SFM2, you must reboot the chassis to activate it.
6.If you are installing additional GBICs in a Gigabit Ethernet module, position the GBIC with its receive connector above its transmit connector.
|
| Cisco 11000 Series Content Services Switch Hardware Installation Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|