
Chapter 1 Unpacking and Installing the CSS
Installing the CSS 11050 or CSS 11150
Installing the CSS 11050 or CSS 11150 as a
Position the CSS 11050 or CSS 11150 on the selected flat surface. When installing the CSS, note that all cables connect to the front of the unit with the exception of the cable that connects to the Ethernet management port on the rear panel and the power cord.
Rack-Mounting the CSS 11050 or CSS 11150
Before you
•Determine if you want to
–
–
•Install the mounting brackets on the CSS. The rack position of the CSS determines where you will install the mounting brackets on the CSS chassis. See the following section to install the mounting brackets.
Installing the Mounting Brackets
Before you begin, you will need the mounting brackets and eight screws shipped in the accessory kit accompanying the CSS 11050 and CSS 11150, and a #2 Phillips screwdriver.
To install the mounting brackets on the CSS chassis:
1.Position the CSS with its front panel facing you. On the left and right side of its chassis, note the screw holes for installing the mounting brackets.
2.Position a bracket on one side of the chassis. Align the bracket with the appropriate screw holes for front- or
Figure 1-2 illustrates front-mounting the brackets. Figure 1-3 illustrates mid-mounting the brackets.
|
| Cisco 11000 Series Content Services Switch Hardware Installation Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|