
Getting Started
Setting Up the Scanner
Installing the Interface Cable
To connect the interface cable:
1.Insert the interface cable’s modular connector clip into the cable interface port on the bot- tom of the scanner handle. (See Figure 1).
2.Gently tug the cable to ensure the connector is properly secured.
3.Connect the other end of the interface cable to the host. (See the specific host chapter for information on host connections.)
Figure 1. Connecting the Interface Cable
Bottom of Scanner
Cable
Cable Strain Relief | Interface Cable Port |
To Host
NOTE
Cable Clip (Latch)
Specific cables are required for connection to different hosts. The connectors illustrated in each host chapter are examples only. Actual connectors may vary from those illustrated, but the steps to connect the scanner remain the same.
6 | QuickScan® L |