Datalogic Scanning QD 2300 manual Scan Line Width, Laser On Time

Scan Line Width

Scan Line Width

Scan a bar code below to set the scan line width. A full scan line width is the default. The medium scan line width is useful for scanning menus or pick-lists.

This feature applies to scanners in Trigger Single Mode only.

NOTE

*Full Width

Medium Width

Laser On Time

This parameter sets the maximum time that decode processing continues during a scan attempt. It is programmable in 0.1 second increments from 0.5 to 9.9 seconds. The de- fault Laser On Time is 3.0 seconds.

To set a Laser On Time, scan the bar code below. Next, scan the two numeric bar codes from Appendix E, Keypad, that correspond to the desired On Time. Single digit num- bers must be padded with a leading zero. For example, to set an On Time of 0.5 seconds, scan the bar code below, then scan the “0” and “5” bar codes. If an error is made, or the selection needs to be changed, scan Cancel on page 166.

This feature applies to scanners in Trigger Single Mode only.

NOTE

Laser On Time

Product Reference Guide 25