Datalogic Scanning QD 2300 manual Keyboard Wedge Parameter Defaults, Keyboard Wedge Defaults

Keyboard Wedge Interface

To connect the Keyboard Wedge interface Y-cable:

Interface cables vary depending on configuration. The connectors illustrated in Figure 1 are examples only. The connectors may be different than those illustrated, but the steps to connect the scanner remain the same.

NOTE

1.Turn off the host and unplug the keyboard connector.

2.Attach the modular connector of the Y-cable to the cable interface port on the scanner. (See Installing the Interface Cable on page 6.)

3.Connect the round male DIN host connector of the Y-cable to the keyboard port on the host device.

4.Connect the round female DIN keyboard connector of the Y-cable to the keyboard con- nector.

5.If needed, attach the optional power supply to the connector in the middle of the Y-cable.

6.Ensure that all connections are secure.

7.Turn on the host system.

8.Select the Keyboard Wedge host type by scanning the appropriate bar code from Key- board Wedge Host Parameters on page 57.

9.To modify any other parameter options, scan the appropriate bar codes in this chapter.

Keyboard Wedge Parameter Defaults

See Appendix B, Standard Defaults for all user preferences, hosts, symbolo- gies, and miscellaneous default parameters.

NOTE

Table 9 lists the defaults for Keyboard Wedge host parameters. To change any option, scan the appropriate bar code(s) in the Keyboard Wedge Host Parameters section begin- ning on page 57.

Table 9. Keyboard Wedge Defaults

Parameter	Default	Page Number
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type	IBM PC/AT& IBM PC Compatibles1	57
Country Types (Country Codes)	North American	58
Ignore Unknown Characters	Send	59
Keystroke Delay	No Delay	60
Intra-Keystroke Delay	Disable	60

56 QuickScan® L