Datalogic Scanning QD 2300 manual Terminal Specific RS-232, Wincor, Parameter

RS-232

Table 6. Terminal Specific RS-232

				Wincor-	Wincor-
	Standard				Nixdorf
Parameter		ICL	Fujitsu	Nixdorf		Olivetti	Omron
	(Default)				Mode B/
				Mode A
					OPOS
Transmit	No	Yes	Yes	Yes	Yes	Yes	Yes
Code ID
Data Transmis-	Data as is	Data/Suffix	Data/Suffix	Data/Suffix	Data/Suffix	Prefix/Data/Suf-	Data/Suffix
sion Format						fix
Suffix	CR/LF	CR (1013)	CR (1013)	CR (1013)	CR (1013)	ETX (1002)	CR (1013)
	(7013)
Baud Rate	9600	9600	9600	9600	9600	9600	9600
Parity	None	Even	None	Odd	Odd	Even	None
Hardware Hand-	None	RTS/CTS	None	RTS/CTS	RTS/CTS	None	None
shaking		Option 3		Option 3	Option 3
Software Hand-	None	None	None	None	None	Ack/Nak	None
shaking
Serial Response	2 Sec.	9.9 Sec.	2 Sec.	9.9 Sec.	9.9 Sec.	9.9 Sec.	9.9 Sec.
Time-out
Stop Bit	One	One	One	One	One	One	One
Select
ASCII Format	8-Bit	8-Bit	8-Bit	8-Bit	8-Bit	7-Bit	8-Bit
Beep On	Disable	Disable	Disable	Disable	Disable	Disable	Disable
<BEL>
RTS Line	Low	High	Low	Low	Low = No data	Low	High
State					to send
Prefix	None	None	None	None	None	STX (1003)	None
*In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can scan bar codes.

**If Nixdorf Mode B is scanned without the scanner connected to the proper host, it may appear unable to scan. If this happens, scan a different RS-232 host type within 5 seconds of cycling power to the scanner.

Table 7. Terminal Specific Code ID Characters

			Wincor-	Wincor-
	ICL	Fujitsu	Nixdorf	Nixdorf	Olivetti	Omron
			Mode A	Mode B/OPOS
UPC-A	A	A	A	A	A	A
UPC-E	E	E	C	C	C	E
EAN-8/JAN-8	FF	FF	B	B	B	FF

34 QuickScan® L