Datalogic Scanning QD 2300 manual User General Feature Defaults, QuickScan L

General Features

User General Feature Defaults

Table 4 lists the factory defaults for the general features described in this chapter, plus provides a place for you to log any special requirements or user-preferred settings at your installation. To change any option, scan the appropriate programming bar code(s) pro- vided in this chapter.

See Appendix B, Standard Defaults for a listing of all programmable features.

NOTE

Table 4. General Feature Defaults

General Feature	Standard Factory	Page Number	Record Your Setting
	Default
Beeper Tone	Medium	22
Beeper Volume	High	22
Power Mode	Continuous On	23
Scanning Mode	Trigger Single	23
Scan Line Width	Full Width	25
Laser On Time	3.0 Sec	25
Beep After Good Decode	Enable	26
Transmit Label ID Character	None	26
Prefix Value	7013 <CR><LF>	27
Suffix Value	7013 <CR><LF>	27
Scan Data Transmission Format	Data as is	26
FN1 Substitution Values	Set	30
Transmit “No Read” Message	Disable	30

20 QuickScan® L