
Chapter 2 Cabling the CSS
Connecting the Console to the CSS
2.Using a
connectors (labeled from left to right, +, |
|
|
|
|
| , respectively). |
|
|
|
|
| ||
|
|
|
|
|
|
|
Warning Before installing a wire, ensure that the polarity of the DC connections is correct. Reversed polarity can cause damage to the DC power supply and can create a dangerous shock hazard.
3.Install the wires into the appropriate connector. Make sure that the uninsulated part of each wire is 9mm (0.35 in.) in length.
When installing the wires, always connect the ground wire first. When disconnecting the wires, always disconnect the ground wire last.
The proper power cable wiring between the CSS 11800 and DC power source is illustrated in Table
Table
CSS 11800 | DC Power Source | ||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| (Ground) |
|
|
|
|
|
|
|
| (Ground) |
|
|
|
|
|
|
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
+ |
|
|
|
|
|
| + |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
– | – | ||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4.Tighten the captive screws to 5 to 7
Connecting the Console to the CSS
To connect a console to the CSS, attach the console cable (provided in the accessory kit) to the Console port on the CSS 11050 or CSS 11150 front panel, or to the CSS 11800 SCM panel. Your terminal settings must match the following CSS default settings:
•Baud Rate: 9600
•Data Bits: 8
•Flow Control: none
| Cisco 11000 Series Content Services Switch Hardware Installation Guide |
|