Cisco Systems 11000 Series manual Connecting a CSS 11050 or CSS 11150 AC Power Cord

Chapter 2 Cabling the CSS

Connecting Power Cords

Connecting a CSS 11050 or CSS 11150 AC Power Cord

To connect an AC power cord to a CSS 11050 or CSS 11150:

1.Ensure that the CSS power switch is in the 0 (off) position.

2.Attach the power cord to the CSS by plugging the AC power cord connector into the power receptacle at the rear panel, as shown in Figure 2-17.

Figure 2-17 Connecting a CSS 11050 or CSS 11150 AC Power Cord

AC -100 -240 VAC 50 - 60HZ 3.1AMax.

49590

AC power cord Power switch

3.Plug the power cord into a dedicated 3-wire grounding receptacle.

4.Switch on the power on the CSS.

Connecting a CSS 11150 DC Power Cord

Before you install a DC power cord, see Appendix A, Specifications for DC power supply safety warnings.

Warning The DC power supply cord requires 18 AWG wire. The CSS 11150 draws a maximum of 25 amps.

Warning DC systems do not have a power switch. A chassis configured for DC power requires an external power disconnect device (such as an external circuit breaker).

	Cisco 11000 Series Content Services Switch Hardware Installation Guide
78-15146-02		2-27