CONFIG Commands
DMT Settings
DSL Commands
set dmt type [ lite dmt ansi multi adsl2 adsl2+ readsl2 adsl2anxm adsl2+anxm ]
Selects the type of Discrete Multitone (DMT) asynchronous digital subscriber line (ADSL) protocol to use for the WAN interface.
Beginning with Firmware Version 7.6, the type value also supports the following settings on certain model units: adsl2, adsl2+, readsl2, adsl2anxm, adsl2+anxm.
☛NOTE:
Some dmt type settings are now supported for many Annex B (335xN) plat- forms. 2200 Series and 33xxN Series models are supported. Currently, adsl2anxm and adsl2+anxm are not supported in Annex B.
set dmt autoConfig [ off on ]
Enables support for automatic VPI/VCI detection and configuration. When set to on (the default), a
set dmt wiringMode [ auto tip_ring A_A1 ]
(not supported on all models) This command configures the wiring mode setting for your ADSL line. Selecting auto (the default) causes the Gateway to detect which pair of wires (inner or outer pair) are in use on your phone line. Specifying tip_ring forces the inner pair to be used; and A_A1 the outer pair.
set dmt metallic-termination [ auto disabled always_on ]
(not supported on all models) Beginning with firmware version 7.5.2, this command allows you to apply a sealing current to “dry” DSL lines so that the wiring doesn’t corrode.
