Configure
ATM Circuits: You can configure the ATM circuits and the number of Sessions. The IP Interface(s) should be reconfigured after making changes here.
Available Encapsulation types: | Available Multiplexing types: | |||
PPP over Ethernet (PPPoE) | LLC/SNAP | |||
PPP over ATM (PPPoA) | VC muxed | |||
Bridged Ethernet |
|
| ||
Routed IP |
|
| ||
None |
|
|
| |
|
|
|
|
|
|
|
|
|
|
Netopia Firmware Version 7 supports VPI/VCI autodetection by default. If VPI/VCI auto- detection is enabled, the ATM Circuits page displays VPI/VCI = 0. If you configure a new ATM VPI/VCI pair, upon saving and restarting, autodetection is disabled and only the new VPI/VCI pair configuration will be enabled.
VPI/VCI Autodetection consists of eight static VPI/VCI pair configurations. These are 0/ 35, 8/35, 0/32, 8/32, 1/35, 1/1, 1/32, 2/32. These eight VPI/VCI pairs will be cre- ated if the Gateway is configured for autodetection. the Gateway does not establish a circuit using any of these preconfigured VPI/VCI pairs, then you can manually enter a VPI/VCI pair in the ATM Circuits page.
ATM Traffic Shaping: You can prioritize
69
