CONFIG Commands
set bridge ethernet option { on off }
Enables or disables bridging services for the specified virtual circuit using Ethernet fram- ing.
set bridge dsl vccn option { on off }
Enables or disables bridging services for the specified interface. Specified interface must be part of a VLAN if bridge is turned on. Only
•show log command will show that WAN Bridge is enabled when at least one WAN inter- face is bridged.
•show ip interfaces and show bridge interfaces commands will show the interfaces that are not in bridged mode and that are in bridged modes, respectively.
set bridge table-timeout [ 30 ... 6000 ]
Sets the timeout value for bridging table timeout. Default = 30 secs; range = 30 secs – 6000 secs
DHCP Settings
As a Dynamic Host Control Protocol (DHCP) server, your Netopia Gateway can assign IP addresses and provide configuration information to other devices on your network dynami- cally. A device that acquires its IP address and other TCP/IP configuration settings from the Netopia Gateway can use the information for a fixed period of time (called the DHCP lease).
Common Commands
set dhcp option { off server relay-agent }
Enables or disables DHCP services in the Netopia Gateway. You must enable DHCP ser- vices before you can enter other DHCP settings for the Netopia Gateway.
If you turn off DHCP services and save the new configuration, the Netopia Gateway clears its DHCP settings.
245
